Sun Microsystems Fire V490 Setup And Rackmounting Manual page 16

The plastic bags of hardware contain screws shown below in actual size.
10-32 Screws (12)
Any screws not used for rackmounting are spares.
Note – Bar nuts are required (but not included) for non-threaded cabinets. See the
instructions provided with your cabinet for more information.
Tools Required
You will need the following tools when rackmounting the server:
Phillips No. 2 screwdriver (Use to tighten 10-32 screws.)
I
Phillips No. 3 screwdriver (Use to tighten M6 screws.)
I
Set of appropriate Allen wrenches to remove the side panels on some cabinets
I
Adjustable wrench to tighten the nuts on the mounting brackets
I
11/32 socket wrench or nut driver (Use to install hinged brackets.)
I
6 Sun Fire V490 Server Setup and Rackmounting Guide • August 2004
M4 Screws (8) M6 Screws (12) 8-32 Lock nuts (4)