Preassembling The Shift Shaft - Husqvarna FS 450 2019 Repair Manual

If deep notches are present:
-
Change the sliding plate.
-
Check guide pin 4) for looseness and wear.
If the guide pin is loose and/or worn:
-
Change the sliding plate.
-
Preassemble the shift shaft.
17.4.40

Preassembling the shift shaft

(0 p. 217)
-
Check clearance
quadrant.
Shift shaft - play in sliding
plate/shift quadrant
If the measured value does not meet specifications:
-
Change the sliding plate.
304682-10
-
Secure the short end of the shift shaft in the bench vise.
I Guideline
Use soft jaws.
-
Mount sliding plate
and put the guide pin on the shift quadrant.
-
Mount pressure spring@}.
-
Slide on spring guide (D, push return spring
offset end facing upward, over the spring guide and lift the
304683-10
offset end over abutment bolt
-
Mount stop disk Q).
O
between the sliding plate and the shift
0.40 ... 0.80 mm (0.0157 ...
0.0315 in)
O
with the guide pin facing downward
8,
0.
ENGINE 17
..
with the
..
217