Replacing The Left Flange Shaft Gasket Ring - Skoda Fabia II 2007 Workshop Manual

– Replace the O-ring -1- at the rigid shaft.
– Replace the circlip -2- at the rigid shaft.
– Insert rigid shaft.
– Tighten the new conical screw on the rigid shaft to the speci‐
fied tightening torque.
– Press the right drive shaft onto the rigid shaft of the gearbox
until the circlip locks in place ⇒ Chassis; Rep. gr. 40 .
– Screw the steering joint to the track control arm -arrows- ⇒
Chassis; Rep. gr. 40 .
– Install protective cap for right drive shaft on the engine
-arrows- ⇒ Chassis; Rep. gr. 40 .
– Change gearbox oil
Note
The gearbox oil must be changed, only in this way the correct gear
oil level can be ensured.
– Install the noise insulation ⇒ Body Work; Rep. gr. 50 .
Specified torques
Component
Rigid shaft on gearbox (conical screw)
Protective cap for drive shaft on engine
1.4 Replacing the left flange shaft gasket
ring
Special tools and workshop equipment required
♦ Inertia extractor - MP9-501 (VW 771)-
♦ Extractor - MP3-419/37 (VW 771/37)-
♦ Socket insert - T10107A- or socket insert 6 mm, commercially
available
♦ Thrust piece - T30028 (3305)-
♦ Tensioning strap - T10038-
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
⇒ "5 Change gearbox oil", page 174
⇒ "1.1 Summary of components - gasket rings and output shafts",
Gearbox 0AM-DSG - Edition 01.2015
.
Nm
page 178
35 Nm
1. Replace gasket rings for rigid shafts and flange shafts
185