Skoda Fabia II 2007 Workshop Manual page 141

– Remove the screw -arrow- and release the coupling rod from
the anti-roll bar on the left side.
Vehicles with the rigid shafts (up to 11.2008)
– Unhook the steering joint from the track control arm and re‐
lease the coupling rods from the anti-roll bar on both sides of
the vehicle.
– Press off the left and right rigid drive shafts from the rigid shafts
of the gearbox, e.g. with wedge - T10161- or tyre iron ⇒ Chas‐
sis; Rep. gr. 40 .
– Tie up the drive shafts as far as possible. Avoid damaging the
paintwork of the drive shafts during this operation.
Vehicles with flange shafts (as of 11.2008)
– Remove drive shafts from flange shafts ⇒ Chassis; Rep. gr.
40 .
– Tie up the drive shafts as far as possible. Avoid damaging the
paintwork of the drive shafts during this operation.
– To remove, insert 2 screws in the right flange and counterhold
the flange shaft using an assembly lever.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
3. Removing and installing the gearbox
137