Skoda Fabia II 2007 Workshop Manual page 161

In some cases, they are installed at the front holder on the gear‐
box.
Note
If a new gearbox is installed, the holders must be modified to the
new gearbox. holder
Transport the gearbox and secure it to the assembly stand
⇒ "4 Transport the gearbox and secure to the assembly support",
page 172 .
3.1.4 Removing gearbox (Rapid NH)
Special tools and workshop equipment required
♦ Supporting device - T30099-
♦ Surface - T30099/1-
♦ Extractor - T10037-
♦ Hook for MP9-200 and T30099 - MP9-200/10 (10-222A/10)-
♦ Removal tool for the inner lining of the door panel -MP8-602/1-
♦ Gearbox mount - 3282-
♦ Bolt - 3282/29-
♦ Adjusting plate - 3282/59-
♦ Tensioning strap - T10038-
♦ Socket insert - T10107 A-
♦ Engine/gearbox jack , e.g. -V.A.G 1383 A-
♦ Spring strap clips , e.g. -VAS 6340-
♦ Socket insert , e.g. -T10035- or socket insert XZN 14 - T10061-
Observe instructions and safety instructions for automatic gear‐
box DSG - 0AM.
♦ ⇒ "2 Safety instructions", page 2
♦ ⇒ "3 Repair instructions", page 4
All cable straps which are detached or cut open when removing,
should be fitted on again in the same place when installing.
If the battery earth strap is disconnected and connected, carry out
additional operations ⇒ Electrical System; Rep. gr. 27 .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
3. Removing and installing the gearbox
157