Skoda Fabia II 2007 Workshop Manual page 74

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
♦ Extractor - T10373-
♦ Supporting bridge - T10323-
♦ Thrust piece - T10368-
♦ Thrust piece - T10376-
♦ Adhesive - AMV 195 KD1 01-
Caution
When replacing the double clutch, the following parts must al‐
ways be replaced too:
♦ the two engaging levers with engaging bearings
♦ on gearboxes up to production date 05.2011: Bearing of
the engaging lever
♦ on gearboxes as of Production date 06.2011: Ball pin of
the engaging lever for clutch K2
♦ Shims for engaging bearing
After replacing the double clutch and the corresponding parts,
the position of the engaging bearings for clutches K1 and K2
will always
⇒ "1.3 Adjust clutch release mechanism", page 41
Note
If all the mentioned parts are only removed and reinstalled,
♦
there is nothing to adjust.
The circlip must be replaced under all circumstances.
♦
Caution
Perform adjustment before installing the double clutch.
If not correctly adjusted, do not continue with further installa‐
tion.
Only one adjusting washer may be installed on all bearings.
The parts of the clutch must be installed free of grease and oil!
The clutch is self-adjusting. Vibrations can have a negative ef‐
fect on the adjusting device. Therefore do not let the clutch fall.
Do not let the clutch fall into the gearbox when installing it.
A clutch that has been dropped on a hard surface, or which is
otherwise damaged, must no longer be installed.
• The mechatronics for double clutch gearbox - J743- is installed
on the gearbox
• The clutch release mechanism is installed
⇒ "1.2 Removing and installing clutch release mechanism",
page 34
– Screw out spindle of the extractor - T10373- .
70
Rep. gr.30 - Clutch
require re-adjusting
.