Skoda Fabia II 2007 Workshop Manual page 98

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
Incorrectly mounted tappets will damage the mechatronics.
The tappets can be put into their correct positions by means of a
hook made from welding wire.
– Tighten all the screws for the mechatronics for double clutch
gearbox - J743- crosswise to the specified tightening torque.
– Turn the assembly lever - T10407- slowly and carefully to the
right and remove it.
• Both clutch adjusters must correctly lock in the recesses of the
engaging levers of the double clutch.
• While doing so, the rubber grommets of the double clutch ad‐
justers should not be damaged.
• The rubber grommets must rest on the mechatronics.
• An incorrect assembly or damage to the rubber grommets
leads to oil leakage in the mechatronics.
– Position the gearbox input r.p.m. sender - G182- in the
-direction of arrow- on the gearbox housing.
– Check gearbox input r.p.m. sender - G182- . The clip must not
be damaged.
• The gearbox input r.p.m. sender - G182- must be positioned
completely and tightly with its tab on the gearbox housing.
• If the sender is loose, the clip of the mechatronics is broken
must be replaced.
– Remove the screw plug from the ventilation and position the
ventilation cap.
94
Rep. gr.34 - Controls, housing