Skoda Fabia II 2007 Workshop Manual page 118

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
– Open the warm-type clamp below the handle -arrow- and pull
off handle with cover.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
♦ To install the selector lever handle, the lock button must be
removed as far as the stop and secured with cable ties or an
assembly aid, which is delivered with the new handle in the
factory.
♦ If the lock button is not secured, this can no longer be removed
from the selector lever handle with mechanical aids. Press out
the lock button if necessary by positioning a compressed air
pistol on the underside of the grip.
– Press the selector lever handle completely onto the selector
lever with a new warm-type clamp.
• The selector lever handle must be positioned with the lock
button in the direction of the driver.
• The handle must latch into the groove on the selector.
– Remove the cable strap or the assembly aid.
After removal, the lock button engages into the vertical groove on
the selector. Where necessary, press the lock button into the se‐
lector lever handle.
– Tighten warm-type clamp using hose binding claw .
– Insert the plug connection -C- for lamp for selector lever scale
illumination - L101- .
Note
When inserting the plug connection -C- ensure that the contact
♦
pins of the lamp for selector lever scale illumination - L101-
are not bent and that the retaining lugs of the cover do not
break off.
Ignore pos. -A-, -B- and -1-.
♦
As of production date 06.2009 the shift mechanism is
♦
changed, the 4-pin plug connection -B- and the selector lever
lock solenoid - N110- -1- are already located in the shift mech‐
anism
⇒ "2.1.2 Summary of components - Gearshift mechanism as
of 06.2009 - (Octavia II, Superb II, Yeti, Rapid NH)",
page 99 .
2.6.2 Removing and installing handle for shift
mechanism as of 11.2012 (CW 45)
Special tools and workshop equipment required
♦ Hose binding claw - V.A.G 1275-
Removing
– Removing the cover for the shift mechanism
⇒ "2.5 Removing and Installing the cover for the shift mecha‐
nism", page 109 .
114
Rep. gr.34 - Controls, housing