Skoda Fabia II 2007 Workshop Manual page 154

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
– Remove the lock washer -arrow- of the selector lever control
cable, the selector lever control cable must be left in the fitting
position.
• The lock washer -arrow- of the selector lever control cable
must always be replaced ⇒ Electronic Catalogue of Original
Parts .
• Do not bend or buckle selector lever control cable.
• Do not press the selector lever control cable out of the cable
support towards the rear. The selector lever control cable is
only guided out of the cable support once the gearbox was
removed.
– Removing starter ⇒ Electrical System; Rep. gr. 27 .
– Remove the earth cable from the holding down bolt of the
gearbox console.
– Release all the upper connecting screws of the gearbox/en‐
gine.
To this end, use if necessary socket insert - T10035- or socket
insert - T10061- .
On some engines, one of the screws is located in the assembly
opening for the starter -arrow-.
– Unscrew engine/gearbox connecting screw -arrow-.
Caution
♦ Under no circumstances must the plug contacts in the plug
of the gearbox be touched with the hands, because the
control unit can be destroyed through static discharge as
well as the mechatronics.
– Grab with the hand (without gloves) at the mass, in order to
discharge yourself electrostatically.
– Unlock the cap of the plug on the mechatronics by pulling in
-direction of arrow- and disconnect the plug.
150
Rep. gr.34 - Controls, housing