Skoda Fabia II 2007 Workshop Manual page 172

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
– Screw the steering joints to the track control arms -arrows- ⇒
Chassis; Rep. gr. 40 .
Vehicles with removed pre-exhaust pipe
– Install pre-exhaust pipe with catalytic converter ⇒ Engine;
Rep. gr. 26 .
– Install charge air pipe (if available) ⇒ Engine; Rep. gr. 21 .
Continued for all vehicles
– Install protective cap for right drive shaft on the engine (if
available). To do so tighten the screws -arrows-.
– Install the charge air hose at bottom left between the charge
air cooler and the charge air pipe ⇒ Engine; Rep. gr. 21 .
– Install the bracket for the pre-exhaust pipe to the assembly
carrier and install the exhaust system free of stress ⇒ Engine;
Rep. gr. 26 .
– The supporting device - MP9-200 (10-222 A)- , where neces‐
sary, remove supporting device - T30099- .
Vehicles Octavia II, Yeti and Rapid NH
– Install the plenum chamber cover ⇒ Body Work; Rep. gr. 66 .
Continued for all vehicles
– Carefully press the selector lever control cable -2- onto the
gearshift lever and secure in the cable support with a new lock
washer -1-.
– Inspect setting of selector lever control cable and adjust if
necessary
⇒ "2.3 Inspecting and adjusting the selector lever control ca‐
ble", page 105 .
– Install the starter motor ⇒ Electrical System; Rep. gr. 27 .
– Install the battery tray and battery ⇒ Electrical System; Rep.
gr. 27 .
– Install air filter ⇒ Engine; Rep. gr. 24 or ⇒ Engine; Rep. gr.
23 .
– Install the front left wheelhouse liner ⇒ Body Work; Rep. gr.
66 .
– Install the noise insulation ⇒ Body Work; Rep. gr. 50 .
– Install front wheel ⇒ Chassis; Rep. gr. 44 .
– If present, install the front left vehicle level sensor - G78- .
• Check the headlight beams setting ⇒ Electrical System; Rep.
gr. 94 .
Perform the
basic setting
with the ⇒ Vehicle diagnostic tester.
Specified torques
♦ Protective cap for drive shaft on engine - 35 Nm
168
Rep. gr.34 - Controls, housing
after the gearbox has been fitted