Skoda Fabia II 2007 Workshop Manual page 147

– Screw on the bracket - T10346- into the rear opening for fas‐
tening the battery tray.
To do so, use a collar screw M6 or one of the fixing screws for the
battery tray.
– Position the supporting device - MP9-200 (10-222 A)- behind
the pressurized gas strut -A- for the front flap.
– The supports of the supporting device - MP9-200 (10-222 A)-
must be placed on the wheelhouse frame side rail, as shown
in the figure.
• The supports must be placed behind the screw -arrow 1- and
to the side and touching screw -arrow 2-.
– Connect the holder - T10346- with the supporting device -
MP9-200 (10-222 A)- .
– Hook the second spindle into the front left engine lifting eye.
– Slightly take up the weight of the engine/gearbox unit via the
spindle, do not raise.
– Loosen the front left wheel bolts.
Vehicles with the rigid shafts (up to 11.2008)
– Loosen the front right wheel bolts.
– Raise vehicle.
– Remove right front wheel.
Continued for all vehicles
– Raise vehicle.
– Remove front left wheel.
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 50 .
– Remove the front left wheelhouse liner ⇒ Body Work; Rep.
gr. 66 .
– Remove the charge air hose from the bottom left charge air
cooler and the charge air pipe ⇒ Engine; Rep. gr. 21 .
– Remove the protective cap for right drive shaft from the engine
-arrows-.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
3. Removing and installing the gearbox
143