Skoda Fabia II 2007 Workshop Manual page 76

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
– Turn the clutch against the extractor - T10373- by hand so that
the clutch finds its fitting position.
The clutch sits on the input shaft in the bottom part when it is
pressed up to the stop, but this is not the optimum position.
The clutch should only be pulled up until it touches the circlip.
– Only rotate the clutch by hand, and do not use any other tool.
The clutch then slides in place against the circlip.
– Place the hub in position.
The hub has a large tooth and therefore only fits in one position.
On the -engine side-, the large tooth has a marking -arrow-.
– Insert the circlip for the hub -arrow-.
• Install the hub with the marking on the large tooth in such a
way that it is flush with the marking on the drive plate
-arrow-.
• Fitting position: The joint of the ring must point to the hub on
the clutch.
72
Rep. gr.30 - Clutch