Table of Contents
Advertisement
Chapter 12 Protocol Decoding
range is from 10% to 90%.
5. Display-related Setting
Press Display to enter the display setting menu.
Set the display format
⚫
Press Format, rotate the multifunction knob
format of the bus data. Then, press down the knob to select it. You can also
press Format continuously or enable the touch screen to select it. The
available display formats of the bus data are "Hex", "Dec", "Bin", and
"ASCII".
Adjust the vertical position of the bus
⚫
Press Position, and then rotate the multifunction knob
vertical display position of the bus. You can also rotate Wave Vertical
POSITION to adjust the vertical display position of the bus.
Set the label display
⚫
Press Label to enable or disable the label display of the CAN decoding bus.
When enabled, the bus label "CAN" will be displayed at the upper-left side
of the bus (when the bus display is enabled).
Event table
⚫
Press Event Table to enter the event table setting menu. The event table
displays the detailed decoding information in time order in the form of a
table, so as to better observe the long decoded data. The decoding
information includes the decoded data, the corresponding line number, time,
frame ID, data length code (DLC), cyclic redundancy check (CRC), and
Acknowledgement (ACK) information.
Open or close the event table: Press Event Table continuously to
➢
enable or disable the event table. When you enable the event table,
the following figure is displayed, as shown in Figure 12-11. You can
also enable the touch screen to tap the icon
corner of the table to close the event table.
MSO8000 User Guide
to select the display
to adjust the
at the upper-right
RIGOL
12-33
Advertisement
Table of Contents
