RIGOL
and error information (MISO and/or MOSI) are displayed in the event
table. If you select "Details", the detailed data in the specified row will
be displayed in the event table. If "..." appears in the row of data, it
indicates that the decoded data are not fully displayed. At this time,
you can view the details in the "Packets" view. If you select "Payload",
all data in the specified column will be displayed in the event table. If
"..." appears in the specified column of data, it indicates that the
decoded data are not fully displayed. At this time, you can view the
details in the "Packets" view.
Export: If you select "Packets", you can export time and the
➢
corresponding decoded data. Press Export, the save setting menu is
displayed. You can export the data table of the packets to the internal
or external USB storage device (when detected) in CSV format. For
detailed saving operation, refer to descriptions in "Store and Load".
Jump to: Set the operating status of the oscilloscope to "STOP". Then,
➢
select the data of the specified time from the event table. Press Jump
to and the specified data waveforms are displayed in the center of the
screen.
Decode: The setting of this menu enables you to quickly view the
➢
corresponding event tables of four decode modules (Decode1,
Decode2, Decode3, and Decode4). Press Decode and rotate the
multifunction knob
the knob to select it. You can also press Decode continuously or
enable the touch screen to select it.
12-24
to select a decode module, then press down
Chapter 12 Protocol Decoding
MSO8000 User Guide