Table of Contents
Advertisement
RIGOL
time. After selecting this condition, you can press Timeout, then rotate the
multifunction knob
The range is from 8 ns to 10 s.
With CS: if the CS signal is valid, the oscilloscope will trigger when the data
⚫
(MISO) satisfying the trigger conditions is found.
Press CS to select the chip selection signal line. The available channels are
➢
CH1-CH4 or D0-D15. For details, refer to descriptions in "Trigger Source".
The current trigger source is displayed at the upper-right corner of the
screen.
Press More → CS Mode to set the current CS mode to "Pos
➢
level is valid) or "Neg
Current Bit:
Press More → Bit X to set the data bit that needs to be operated on. For setting
methods, refer to descriptions in "I2C Trigger (Option)".
Data Bits:
Press More → DataBits, then rotate the multifunction knob
numeric keypad to set the number of bits in the serial data string. The number of bits
in the string can be set to any integer ranging from 4 and 32.
Trigger Mode:
In the trigger control area (Trigger) on the front panel, press Mode to quickly switch
the current trigger mode. For details, refer to descriptions in "Trigger Mode".
Trigger Parameter Setting:
Set the trigger parameter (noise rejection) under this trigger type. For details, refer
to descriptions in "Noise Rejection".
Trigger LEVEL/Threshold Level:
Rotate the Trigger
to "Trigger LEVEL/Threshold Level". The current trigger level/threshold level
value is displayed at the upper-right corner of the screen.
5-40
or use the pop-up numeric keypad to set the idle time.
" (low level is valid).
LEVEL knob to adjust the trigger level/threshold level. Refer
Chapter 5 To Trigger the Oscilloscope
or use the pop-up
MSO8000 User Guide
" (high
Advertisement
Table of Contents
