Table of Contents
Advertisement
Chapter 1 Quick Start
Parameter Setting Method
You can use the knob or enable the touch screen to set the parameters of MSO8000
series. The common parameter setting methods are as follows:
Method 1:
For the parameters with the sign
panel directly to select the parameter item or modify the parameter value.
Method 2:
For the parameters with the sign
panel and press it down to select the parameter item or modify the parameter value.
Method 3:
For the parameters with
on the front panel directly to set the parameter, or press down the multifunction
knob
or the specified menu softkey, and then the numeric keypad is shown in
Figure 1-20 below.
In the numeric keypad, rotate the multifunction knob
then press down the knob to select it. Then input the value or the unit. You can also
enable the touch screen and tap the value or unit in the numeric keypad to input
them. After you input all the values and select the desired units, the numeric keypad
is turned off automatically. This indicates that you have completed parameter setting.
Besides, after you have input the values, you can also press OK directly to close the
numeric keypad. At this time, the unit of the parameter is the default unit. In the
numeric keypad, you can also perform the following operations:
Delete the parameter value that has been input.
⚫
Set the parameter to a maximum or minimum value (sometimes, the maximum
⚫
or minimum value are the specified one for the current state).
Set the parameter to a default value.
⚫
Clear the parameter input field.
⚫
MSO8000 User Guide
, rotate the multifunction knob
, rotate the multifunction knob
displayed on the menu, rotate the multifunction knob
Figure 1-20 Numeric Keypad
on the front
on the front
Parameter
Input Field
Delete key
Max. value
Min. value
Default
Clear key
to select the parameter,
RIGOL
1-29
Advertisement
Table of Contents
