Table of Contents
Advertisement
RIGOL
Audio:
Press Audio continuously or rotate the multifunction knob
"Right", or "Either".
Trigger Condition:
Press More → When, and rotate the multifunction knob
trigger condition, then press down the knob to select it. You can also press When
continuously or enable the touch screen to select it.
=: triggers when the channel's data equal the set data value. Press Data to set
⚫
the data bit. For setting methods, refer to descriptions in "I2C Trigger
(Option)".
≠: triggers when the channel's data do not equal the set data value. Press Data
⚫
to set the data bit. For setting methods, refer to descriptions in "I2C Trigger
(Option)".
<: triggers when the channel's data are smaller than the set data value. Press
⚫
Data Max to set the upper limit of the data bit. For setting methods, refer to
descriptions in "I2C Trigger (Option)".
>: triggers when the channel's data are greater than the set data value. Press
⚫
Data Min to set the lower limit of the data bit. For setting methods, refer to
descriptions in "I2C Trigger (Option)".
><: triggers when the channel's data are smaller than the upper limit of the
⚫
data value and greater than the lower limit of the data value. Press Data Max
and Data Min to set the upper limit and lower limit of the data bit respectively.
For setting methods, refer to descriptions in "I2C Trigger (Option)".
<>: triggers when the channel's data are greater than the upper limit of the
⚫
data value and smaller than the lower limit of the data value. Press Data Max
and Data Min to set the upper limit and lower limit of the data bit respectively.
For setting methods, refer to descriptions in "I2C Trigger (Option)".
Width:
Press More → Width, then rotate the multifunction knob
numeric keypad to set the width. Its range is from 4 to 32.
User Width:
Press More → User Width, then rotate the multifunction knob
pop-up numeric keypad to set the user width. Its range is from 4 to 32.
Note:
The user width is smaller than or equal to the width.
Alignment:
Press More → Alignment and rotate the multifunction knob
alignment way for data signal. You can also press Alignment continuously to select
the alignment way or enable the touch screen to tap the desired alignment way and
select it.
I2S: MSB (Most Significant Bit) of data for each sample is sent first, and LSB (Least
5-50
Chapter 5 To Trigger the Oscilloscope
to select "Left",
to select the desired
or use the pop-up
or use the
to select the
MSO8000 User Guide
Advertisement
Table of Contents
