Table of Contents
Advertisement
RIGOL
1. Select English Input Method
If the current input method is "En/中/繁", please go to Step 2. If the current
input method is "中/繁/En" or "繁/En/中", rotate the multifunction knob
select the input switch key and press the knob
"En/中/繁". "En" is located first and highlighted.
2. Clear the Name Input Area
If there is no character in the "Name Input Area", please go to Step 3. If there
are characters in the "Name Input Area", press rotate the multifunction knob
to select the Delete key
in order.
3. Input the First Character "F"
1)
If the current setting is uppercase input, please go to Step 2). If the current
setting is lowercase input, rotate the multifunction knob
"Caps" and press down the knob to switch to the uppercase input.
2)
Rotate the multifunction knob
Then the letter is displayed in the name input area.
4. Input the Other Characters
Use the same method to input the remaining letters "ilename" by referring to
Step 3. Pay attention to the upper-lower case of the letters when inputting them.
5. Modify or Delete the Unwanted Characters that Have Been Entered.
While entering a filename, you can modify or delete the unwanted character if
necessary. To delete the input characters, rotate the multifunction knob
the virtual keypad to select the delete key
characters. To modify the input characters, delete the unwanted characters and
input the desired characters again. If the character to be modified is in the
middle, press the delete key
one to the character to be modified, then input the new character again.
If the touch screen is enabled, tap to directly move the cursor to the character
required to be modified or deleted, and then input the desired character again or
delete the unwanted character.
Tip
If characters already exist in the letter input area, when you rotate the
multifunction knob
characters in the letter input area will be deleted first.
6. After finishing the input, rotate the multifunction knob
oscilloscope will create a folder or a specified type of file with this name under
the current directory.
19-12
to delete all the characters in the name input area
to select "F" and press down the knob.
to delete the characters starting from the last
to delete the characters in the name input area, the
Chapter 19 Store and Load
continuously to switch to
. Press down the key to delete the
and press OK. The
MSO8000 User Guide
to
to select
in
Advertisement
Table of Contents
