Table of Contents
Advertisement
RIGOL
upper-left side of the bus (when the bus display is enabled).
Event table
⚫
Press Event Table to enter the event table setting menu. The event table
displays the detailed decoding information in time order in the form of a
table, so as to better observe the long decoded data. The decoding
information includes the decoded data, the corresponding line number, time,
frame ID, and Payload Length (PL).
Open or close the event table: Press Event Table continuously to
➢
enable or disable the event table. When you enable the event table,
the following figure is displayed, as shown in Figure 12-13. You can
also enable the touch screen to tap the icon
corner of the table to close the event table.
Line Number
Event Table
FlexRay Bus
Note:
⚫
⚫
Set the event table format: Press Format, rotate the multifunction
➢
knob
press down the knob to select it. You can also press Format
continuously or enable the touch screen to select it. The available
formats include "Hex", "Dec", "Bin", and "ASC".
12-38
Time Frame ID PL Header CRC Cycle Decoded Data Frame CRC
Figure 12-13 FlexRay Decoding Event Table
When you adjust the horizontal time base, the waveform displayed
on the screen will also change, and the total number of lines
containing the decoding information in the event table will also be
changed.
The displayed decoded data information in the bus is related to the
value of the horizontal time base. Reducing the horizontal time
base can help you view the detailed information.
to select the display format of "Data" in the event table. Then,
Chapter 12 Protocol Decoding
at the upper-right
MSO8000 User Guide
Advertisement
Table of Contents
