ELECTRO FREEZE FREEDOM 360 Series Operator's Manual page 29

6.3 Cleaning Instructions
center plunger ports, O-ring grooves,
dispense nozzle mounting rings, and mix
ports, as shown in figure 6-6.
and O-rings, plunger O-ring grooves and
nozzles, as shown in figure 6-7.
grooves.
scraper blade pin holes as shown in
figure 6-8.
Do not leave parts in sanitizer for
more than 15 minutes.
and then place them in the sanitizer
solution. Brush the inside of all mix
transfer hoses with sanitizer. For proper
sanitizing, the parts must remain fully
immersed in the sanitizer for 5 minutes.
Allow parts to air-dry after sanitizing.
solution thoroughly brush; the mix feed
tubes from the refrigerated cabinet to the
cylinders as shown in figure 6-9, the
inside of the cylinders including the back
wall, and the inside of the drain tube, as
shown in figure 6-10. Then rinse with
clear water and brush with sanitizing
solution.
Wash in a warm dish detergent solution,
rinse with clear water, and brush with
sanitizing solution
and inside of the cabinet with a warm
dish detergent solution. Rinse with clear
water.
parts. See Accessories parts
list in Part II of this Manual to
184621
b. The head plunger openings,
c. The shaft cup seals, washers,
d. The air bleed plug O-ring
e. The beater shaft and the
Important:
3. After all parts are washed, rinse
4. Using a warm dish detergent
5. Remove the drip tray and insert.
6. Wash the outside of the freezer
Replace worn brushes. Use
only Electro Freeze original
or authorized replacement
order new brushes.
ELECTRO FREEZE Soft Serve Model 99T-RMT
(continued)
Figure 6-7
Figure 6-8
Figure 6-9
Figure 6-10
Clean O-ring grooves, seal
and nozzle with brush.
Clean beater shaft pin holes.
Brush inside of cylinder mix
feed tubes.
Brush inside of drain tube
21