ELECTRO FREEZE FREEDOM 360 Series Operator's Manual page 55

12 Troubleshooting Table
PROBLEM
Compressor and 1.
beater motor do
not operate
2.
when
dispensing.
3.
4.
Cabinet too cold 1.
(below 35°F
[1.7°C])
2.
Cabinet too 1.
warm (above
41°F [5°C]).
2.
3.
4.
5.
6.
184637
PROBABLE CAUSE
Plunger switch(es) defective or out of
adjustment.
Time delay defective.
Control relay defective.
Out on HPCO or LPCO.
Cabinet thermostat setting too low.
Defective thermostat.
Top of freezer obstructed.
Cabinet thermostat defective set too
warm or turned off.
Cabinet switch defective.
Door switch defective.
Cabinet compressor defective.
Cabinet refrigeration system problem.
ELECTRO FREEZE Soft Serve Model 99T-RMT
(continued)
1. Contact your Electro Freeze Distributor
for service.
2. Contact your Electro Freeze Distributor
for service.
3. Contact your Electro Freeze Distributor
for service.
4. Contact your Electro Freeze Distributor
for service.
1. Contact your Electro Freeze Distributor
for service.
2. Contact your Electro Freeze Distributor
for service.
1. Clear top of freezer. Freezer needs at
least 18 inches of space on top panel.
2. Contact your Electro Freeze Distributor
for service.
3. Contact your Electro Freeze Distributor
for service.
4. Contact your Electro Freeze Distributor
for service.
5. Contact your Electro Freeze Distributor
for service.
6. Contact your Electro Freeze Distributor
for service.
REMEDY
47