ELECTRO FREEZE FREEDOM 360 Series Operator's Manual page 27

6.2 Disassembly Instructions
Figure 6-3 Shaft Seal
handles (10,12), plungers (4,8) and
nozzles (13) from the dispense head.
dispense head and O-rings (2) from
the plungers (4,8).
6-3) and O-rings from the plastic
washers on the shaft seal assemblies.
low mix probes.
Figure 6-4 MTS
184621
ELECTRO FREEZE Soft Serve Model 99T-RMT
WASHER
O-RING
7. Remove the handle pin (9),
8. Remove O-rings (3) from the
9. Remove the cup seals (figure
10. Remove mix tanks, covers and
(continued)
11. Remove MTS cover.
12. Remove MTS hose assemblies
from the Mix Transfer Systems as follows
CUP SEAL
(figure 6-4):
a. loosen the hand knob,
b. swing back the shoe clamp,
c. swing open the roller shoe,
d. loosen the clamp on braided
hose,
e. pull tube off cylinder inlet and
slide hose assembly out of roller support
housing.
13. Disassemble MTS hose
assembiles as shown in figure 6-5.
Figure 6-5 MTS Hose Assembly
19