ELECTRO FREEZE FREEDOM 360 Series Operator's Manual page 32

ELECTRO FREEZE Soft Serve Model 99T-RMT
7 Assembly
Figure 7-4 Dispense Head Assembly
then lubricate the O-rings (2) on the
dispensing plungers (4,8) and insert all
three halfway into the head (1).
inch head O-rings (3).
the head and ensure that the longest
handle (12) is in the center plunger. Lock
in place with the handle pin (9).
on the air bleed plugs (6). Insert plugs in
the head assembly.
surface of each cylinder bushing and
place one on the end of each beater
shaft.
24
(continued)
6. (Refer to figure 7-4.) Install and
7. Install and then lubricate the 4-
8. Position the handles (10,12) in
9. Install and lubricate O-rings (5)
10. Lubricate the inside bearing
Important:
ALWAYS make sure the head bushing
is positioned in the head properly.
Operating the freezer with a missing
or badly worn bushing will damage
the beater, dispense head and cylin-
der.
Important:
Excessive force will damage the
head. Do not use tools to tighten.
11. Install the dispensing head onto
the freezer by aligning the studs with the
holes in the head and sliding toward the
freezer. Tighten the hand knobs evenly,
finger-tight only.
12. Install the plunger rods. The
nozzles will be installed on the mix outlet
at the bottom of the dispense head after
sanitizing.
—continued
184621