Teletek electronics MAG8Plus Installation And Operation Manual page 24

Sounders Enable/Disable
To disable the sounders:
• Press
• Press
reach the last zone in the
system - 4, 8, 12 or 16.
• Press
• Press
• Press
button to exit the
sounder disabling mode:
You can exit the sounder disabling mode also by pressing the
that case the procedure for initial start-up will not run.
To enable the sounders:
• Press
• Press
reach the last zone in the
system - 4, 8, 12 or 16.
• Press
• Press
• Press
button to exit the
sounder enabling mode:
You can exit the sounder enabling mode also by pressing the
that case the procedure for initial start-up will not run.
24 MAG8Plus - Installation and Operation Manual
button:
button until you
button once again:
button:
button:
button until you
button once again:
button:
DISABLE/ ENABLE LED blinks.
The ZONE 1 LED blinks in yellow (2 blinks
per second) if ZONE 1 is enabled and
lights permanently if ZONE 1 is disabled.
The SOUNDER FAULT/ DISABLE LED
will start blinking.
The SOUNDER FAULT/ DISABLE lights
up permanently.
That will initialize the start-up procedure
and introduce the changes (item 6.1).
At this point the sounders are disabled.
DISABLE/ ENABLE LED blinks.
The ZONE 1 LED blinks in yellow (2 blinks
per second) if ZONE 1 is enabled and
lights permanently if ZONE 1 is disabled.
The SOUNDER FAULT/ DISABLE LED
lights up permanently in yellow.
The SOUNDER FAULT/ DISABLE will
start blinking.
That will initialize the start-up procedure
and introduce the changes (item 6.1).
At this point the sounders are enabled.
button, as in
button, as in