Master Panel Mode; Repeater Panel Mode; Single Panel Mode - Teletek electronics MAG8Plus Installation And Operation Manual

4 Zone
Expander
Figure 26. Example for Instant Action Mode Programming.

5.4 Master Panel Mode

When connecting two MAG8Plus panels in a common system, the first must be pro-
grammed as Master and the second as Slave.
In order to program the Master Panel mode:
• Set a jumper on the Master position of the main module - Figure 10.
• Press
to introduce changes.
The connection between the Master Panel and the MR8 module relays is described in
item 4.1, and the connection between the Master Panel and the Slave - in item 4.2.

5.5 Repeater Panel Mode

In order to program the Repeater Panel mode:
• Set a jumper on the Slave position of the main panel module - Figure 10.
• Press
to introduce changes.
The connection between the Master Panel and the Slave is described in item 4.2.

5.6 Single Panel Mode

No jumper is set on the Master or Slave position in Single Panel Mode of the
MAG8Plus.
In order to program the Single Panel mode:
• Check whether there are jumpers set on the Master or Slave position. Remove them
if any.
• Press
to introduce changes.
20 MAG8Plus - Installation and Operation Manual
Zone 1
z1
z2
z3
z4
D1 1 DN