Table of Contents
Advertisement
3.1 Wall Mounting
• Use the template supplied to determine
the openings of the metal bottom onto the
wall - Figure 4.
• Drill Ø6-8mm diameter openings in the
wall and fix the box using the provided
anchors and screws (Positions 2 and 4,
page 31) - Figure 5.
TEMPLATE
DRILL HERE
FLUSH MOUNTING
Figure 4.
3.2 Flush Mounting
The accessory set provided contains two special hangers for flushed wall mounting
(position 20, page 31) of the fire alarm panel on 25 mm thick drywall.
• Use the dimension shown in Figure 6 to draw and cut out the mounting openings in
the drywall.
• Attach the hangers to the internal side of the wall and fix them with the screws (Position
19, page 31), as shown in Figure 7, Position 1.
• Run all external cables in the box and then place it into the mounting opening. Fix the
bottom using the mounting screws and washers (Positions 17 and 18, page 31) - Figure
7, Position 2.
Figure 6.
HANGER
SCREWS FOR
HANGER FIXING
MAG8Plus - Installation and Operation Manual
Figure 5.
WASHER
Figure 7.
25mm THICK
DRYWALL
METAL BOX
SCREWS FOR
FLUSH MOUNTING
7
Advertisement
Table of Contents
