6.5 Sound Signal
• Short beeps - After pressing the
• Continuous beep - Fire and/ or Fault status. The signal can be stopped by pressing the
button, but the LED indication remains.
• Interrupted beep - After pressing the
sounders and the
signal can be stopped by pressing the
remains.
6.6 Service Modes
Zone Enable / Disable
Each zone of MAG8Plus can be enabled or disabled.
To disable a zone:
• Press
• Press
the zone which has to be disabled:
• Press
• Press
button:
To enable a zone:
• Press
• Press
the disabled zone:
• Press
• Press
button:
button to access "One Man" test mode of zones. The
button:
button, until you reach
button:
button:
button until you reach
button:
MAG8Plus - Installation and Operation Manual
and upon the initial start-up of the panel
button to enable/disable zones/
button, but the LED indication
DISABLE/ ENABLE LED blinks.
The ZONE 1 LED blinks in yellow (2 blinks
per second) if ZONE 1 is enabled and
lights permanently if ZONE 1 is disabled.
The respective zone LED blinks in yellow
(2 blinks per second).
The LED of the disabled zone lights
permanently in yellow.
That will run the procedure for initial
start-up of the panel (item 6.1).
At this point the zone is disabled.
DISABLE/ ENABLE LED blinks.
The ZONE 1 LED blinks in yellow (2 blinks
per second) if ZONE 1 is enabled and
lights permanently if ZONE 1 is disabled.
The LED of the disabled zone lights
permanently in yellow.
The zone LED will start blinking in yellow
(2 blinks per second).
That will initialize the start-up procedure
and introduce the changes (item 6.1).
At this point the zone is enabled.
23