Upnp Configuration; Nat Configuration; View Network Status; Basic Configuration - Vitek VT-TR5HA1620 Manual

11.1.6

UPnP Configuration

By UPnP you can access the DVR through IE client which is in a WAN via router without port
mapping.
Click StartàSettingsàNetworkàUPnP to go to the following interface.
Make sure the router supports UPnP function and the UPnP is enabled in the router.
Set the DVR's IP address, subnet mask and gateway and so on corresponding to the router.
Check "Enable" in the interface as shown below and then click "Apply" button.
Click "Refresh" button to refresh the UPnP status. If the UPnP status were still "Invalid UPnP"
after refreshing it for many times, the port number would be wrong. Please change the mapping
type to "Manual" and then click
UPnP". Refer to the following picture. You can view the external IP address of the DVR. Input
the external IP address plus port in the IE address bar to access the DVR such as
http://183.17.254.19:81.
11.1.7

NAT Configuration

Click StartàSettingsàNetworkàNAT to go to the interface for NAT configuration. Check
"Enable" and then select the NAT server address (nat.autonat.com by default). Click "Apply"
to save the settings.
You can scan the QRCode through the mobile client which is installed in the mobile phone or
PAD to log into the mobile client instantly.
11.1.8

View Network Status

Click StartàSettingsàNetworkàNetwork Status to view the network status or click
the tool bar at the bottom of the live preview interface to view network status.
11.2

Basic Configuration

11.2.1

Common Configuration

Click StartàSettingsàSystemàBasicàGeneral Settings to go to the following interface. Set
the device name, device No., language, video format and main output resolution. Enable or
Transcendent VT-TR5HA DVR Series
to modify the port until the UPnP status turns to "Valid
92
on