Advanced Configuration; Encode Parameters Setting - Vitek VT-TR5HA1620 Manual

7.1.2

Advanced Configuration

Click StartàSettingsàRecordàAdvanced to go to the following interface. Enable or disable
cycle record (cycle record: the earliest recorded data will be replaced by the latest when the
disks are full). Set the pre-alarm record time, post-alarm record time and expiration time of
each camera and then click "Apply" to save the settings.
Pre-alarm Record Time: set the time to record before the actual recording begins.
Post-alarm Record Time: set the time to record after the actual recording is finished.
Expiration Time: set the expiration time for recorded video. If the set date is overdue, the
recorded data will be deleted automatically.
7.2

Encode Parameters Setting

Click StartàSettingsàRecordàEncode Parameters to go to the interface as shown below. Set
the encode, resolution, FPS, bitrate type, quality, max bitrate and audio of main stream for each
camera in "Event Recording Settings" and "Schedule Recording Settings" interfaces. Click
"Apply" to save the settings. You can set the record stream of each camera one by one or batch
set them for all cameras.
Click StartàSettingsàRecordàStream Settings to go to "Sub Stream" interface. Set the
encode, resolution, FPS, bitrate type, quality and max bitrate of sub-stream for each camera in
the interface and then click "Apply" to save the settings.
Transcendent VT-TR5HA DVR Series
50