Removal Procedure; Lap Bar Assist Gas Spring - Terex ASV SR70 Service & Repair Manual

Rubber Track Loader
6. Operator Enclosure
Rear Interior Panel
Removal
Required Tools
Phillips Type Screwdriver
6-26
1. Remove the screws holding the rear panel to the
cab. (fig. 6-26)
6-27
2. Disconnect the rear power point from the harness,
then remove the panel from the cab. (fig. 6-27)
Installation
1. To re-install the rear interior panel, reverse the

removal procedure.

Lap Bar Gas Spring
Removal
Required Tools
Phillips & Blade Type Screwdrivers
1. Remove the right, left and rear interior panels from
the cab to access the gas spring.
6-28
2. Put the lap bar in the raised position to relieve ten-
sion on the lap bar gas spring. (fig. 6-28)
6-29
3. Using a small screwdriver, remove the retaining
clip from each end of the gas spring. (fig. 6-29)
4. Remove the gas spring by pulling both ends off of
the ball joints.
Installation
1. Reverse the removal procedure to reinstall the lap
bar gas spring.
6-6
https://tractormanualz.com/