Table of Contents
Advertisement
Messages
Messages such as the following are displayed as required.
Messages Related to the Drive Interface
Table-D6
Message
Drive status
Calibrate
The drive is being calibrated.
Cleaning
The drive is being cleaned.
Erasing
The drive is erasing.
Loading
The drive is loading.
Locating
The drive is locating.
Reading
The drive is reading.
Rewinding
The drive is rewinding.
REQ clean
The drive is requesting a cleaning.
Unloading
The drive is unloading.
Waiting for loading completion following execution of the Load command.
Wait load
Wait unload
Waiting for unloading completion following execution of the Unload command.
Writing
The drive is writing.
DRV full
There is a cartridge in the drive.
DRV empty
There isn't a cartridge in the drive.
Autoloader and Drive
COMM.ERROR
The Autoloader detected a communication error with the drive.
Drive error and caution
DRV Err 1
There has been detection of the drive exceeding the recommended operation temperature.
There has been detection of the drive input voltage reaching the limit of or exceeding the
DRV Err 2
permissible range.
DRV Err 3
A drive firmware error has occurred.
DRV Err 4
A fault has occurred in the drive firmware or hardware.
DRV Err 5
A fault has occurred in the drive hardware.
DRV Err 6
A drive hardware or a media error has occurred.
DRV Err 7
A fault of the media has occurred.
DRV Err 8
An error has occurred in the drive hardware or SCSI bus.
DRV Err 9
An error has occurred in the drive hardware or RS-422 connection.
DRV Err A
An error has occurred in the drive hardware.
Table of Messages Related to the Drive Interface
Description
- 67 -
Advertisement
Table of Contents
