Table of Contents
Advertisement
Operation 2
Press the "ENTER" key.
Display: STATUS
Press the "arrow" key and select the LOAD command.
Operation 3
Display: LOAD
Operation 4
Press the "ENTER" key and define the command.
Display: Load Drv?
Operation 5
Press the "arrow" key and select "Load Slt?" .
Display: Load Slt?
Operation 6
Press the "ENTER" key and execute the command.
Display: Complete (when the command ends normally.)
Err. xxxxxx (when an error occurs. xxxxxx is the error code.)
Tip
• Loading by command is valid only when slots 8 to 10 among the fixed slots
are all vacant slots.
• When loading by command is executed, all cartridges housed in slots 5 to 7
within the magazine are moved to fixed slots.
Important
For using the Tandberg LTO2 Autoloader w/BCR
In using the LTO2 Autoloader w/BCR, slot 10 must be a free slot used
to swap a cartridge during the inventory scan process. When you load the 2
cartridges to the fixed slots, i.e. slot 8 and slot 9, you can insert the cartridges
into slot 5 and slot 6 only. If a cartridge is in slot 7, loading command is
failed and error message of "S10 forBCR" is displayed on the LCD.Then,
you remove the cartridge fro slot7 manually, and retry the loading command.
- 18 -
Advertisement
Table of Contents
