Changing The Scsi Id - Tandberg Data Autoloader Tandberg LTO2 Installation And User Manual

3.6.2 Changing the SCSI ID

Operation Example 1
The operation procedure and LCD indications are described below when changing the SCSI ID
of the Autoloader from 0 to 1.
Operation 1
Operation 2
Operation 3
Operation 4
Operation 5
Operation 6
Operation 7
Operation 8
Operation 9
Operation 10
Operation 11
Switch ON the power and wait for the completion of the power-on test.
Display: "READY" and "DRV empty" are alternately displayed.
Press the ENTER key.
Display: STATUS
Press the arrow key and select the "SCSI ID" command.
Display: SCSI ID
Press the ENTER key and define the command.
Display: View ID?
Press the arrow key and select the "Set ID" command.
Display: Set ID?
Press the ENTER key and define the command.
Display: Lib.ID?
Press the ENTER key and define the command.
Display: Lib. ID 0?
Press the arrow key and select the "Lib. ID1" command.
Display: Lib. ID 1?
Press the "ENTER" key and define the command.
Display: Complete
Set the power switch of this device to OFF.
Switch the power of this device ON again.
- 27 -