Table of Contents
Advertisement
Error code
There has been detection of the drive
DRV Err 1
exceeding the recommended operation
temperature.
There has been detection of the drive
DRV Err 2
input voltage reaching the limit of or
exceeding the permissible range.
DRV Err 3
A drive firmware error has occurred.
A fault has occurred in the drive
DRV Err 4
firmware or hardware.
A fault has occurred in the drive
DRV Err 5
hardware.
A drive hardware or a media error has
DRV Err 6
occurred.
DRV Err 7
A fault of the media has occurred.
An error has occurred in the drive
DRV Err 8
hardware or SCSI bus.
An error has occurred in the drive
DRV Err 9
hardware or RS-422 connection.
An error has occurred in the drive
DRV Err A
hardware.
The Autoloader detected
COMM.ERROR
communication error with the drive.
The Autoloader is requesting the
REQ CLNROL
cleaning of the Roller.
The door has been forced open during
FATEL ERR.
the transporter operation and the
magazine has been removed.
The Autoloader detected transporter
MOVE ERROR
error during Load or Unload cartridge.
The Autoloader detected SCSI parity
SCSI P Err
error.
Cause
Improve the enviroment temperature.See Appendix
A
Contact your nearest Customer Support Center.
Contact your nearest Customer Support Center.
Replace the cartridge.
Replace the cartridge.
Contact your nearest Customer Support Center.
･Switch off the power of the Autoloader and then
switch the power back on.
･ If the phenomenon has a relapse,contact your
nearest Customer Support Center.
･Execute cleaning of the Roller.See"Section 5.1.2"
･Switch off the power of the Autoloader and then
switch the power back on.
･Execute cleaning of the Roller.See"Section 5.1.2"
･ If the phenomenon has a relapse,contact your
nearest Customer Support Center.
･ Check the conection of SCSI cable and SCSI
terminator.
- 59 -
Recovery Procedure
Advertisement
Table of Contents
