Switching On The Power Switch And The Power-On Sequence; Scsi Id Setting - Tandberg Data Autoloader Tandberg LTO2 Installation And User Manual

Tandberg data tandberg lto2 autoloader installation and user's manual
Table of Contents

Advertisement

2.5 Switching ON the Power Switch and the Power-On
Sequence
Switching ON the power of the Autoloader executes an automatic power-on sequence.
1. Connect the AC power cable.
2. Press the right side ( | ) of the Autoloader front panel power switch to switch the power ON.
3. When the power is supplied, the POWER LED lights in green and the power-on test starts.
4. When the power-on test ends normally, "READY" and "DRV empty" are alternately
displayed on the top level of the LCD.
Power switch

2.6 SCSI ID Setting

Please check that the SCSI ID of the Autoloader is not already being used by a
server/workstation or another SCSI device. (Prior to shipping from the factory, the SCSI ID of
the Autoloader was set as described below.)
See "3.6 Setting the SCSI ID" for information about how to check the SCSI IDs that have been
set and for the method of changing them when required.
Important
The Autoloader and the tape drive must each have an independent SCSI ID.
This device has a specification that does not allow duplication of the tape drive
and Autoloader IDs. Please check that the IDs of other SCSI devices on the
same SCSI bus do not duplicate the IDs of the tape drive and the Autoloader.
SCSI ID at time of factory shipping
Figure 2-6 Powering on the LTO2 Autoloader
- 12 -
Tape drive
: (1)
Autoloader
: (0)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Autoloader Tandberg LTO2 and is the answer not in the manual?

Table of Contents