Datamax Prodigy Plus Operator's Manual page 24

Char
m Set metric flag, enter metric mode
O Form edge offset (start of print
position)
o Cycle cutter
P Enter character dump mode
p Controlled pause
Q Clear all memory modules
q Clear module
r Select reflective sensor
S Slew (feed) speed
s Set up for one print buffer
T Printhead dot pattern test label
t Test RAM memory module
(Must be in Test Mode)
U Label format field replacement
V Software switch settings
v Firmware version information
W Request memory module information
w Test FLASH module memory
X Set default module bank
Y Output sensor values
Z Print internal information and dot
pattern
Table 2-3 System-Level Commands (Continued)
16
Description
Printer Setup
All references set to metric until reset
Onnnn = 4 digits, in/100 or mm/10
qx = Module I.D. (Uppercase)
Used for "black-strip" media sensing,
(e.g. continuous tags, butt-cut labels.
Stripe must be printed on back side of
media)
Sx x = C-0, 2-8 ips
a bbbK 'Module Good'
A=1(top slot) B=2 (bottom slot)
bbb = 256 or 512, for size of module
Vn n = 4-Label Present, 2-color ribbon,
1-Cutter Enable
Sends version string to Host
Wx x = F-font, G-graphic, L-label
Takes about 90 seconds
Xa a - A = Memory Module A
Dumps sensor values status to
RS-232 port
Format
Prodigy Plus