Printhead Alignment Procedure; Label Stock Tracking Adjustment - Datamax Prodigy Plus Operator's Manual

3.3 Printhead Alignment Procedure

Depending on the degree of alignment necessary to your Printhead,
one or perhaps all of the steps mentioned below may need to be
completed.

3.3.1 Label Stock Tracking Adjustment

To ensure that the stock feeds straight use a full roll of 4" (102
mm) or 4.25" (108 mm) wide stock and complete the
following steps:
1. Rotate the Media Guide 'down' and install the stock,
2. Press the feed button to feed the labels until the stock
3. Rotate the Media Guide to the up position and slide
28
Troubleshooting
keep the Media Guide in the down position.
begins to track at a stable position.
the Media Guide in or out until the inside edge of the
stock is gently resting against the inner Media Guide.
Prodigy Plus