Fuse Replacement - Datamax Prodigy Plus Operator's Manual

3.4 Factory Default Setup
With the Printer off, press and hold the feed, cancel, and pause buttons
while turning the Printer on. Continue to hold the buttons until the
Ribbon Media LED illuminates a second time. The Printer will now be
set to the 'Factory Defaults'.
3.5

Fuse Replacement

The Printer uses a 2.0 amp/250V slo-blo fuse, which is located within the
voltage selection switch, just below the power switch.
Turn off the Printer and remove the AC power cord.
Insert a flat-bladed screwdriver in the release slot and push out the
fuse holder/voltage selector switch.
Replace the fuse with the same type and rating, (250volts, 2Amp,
slo-blo).
42
Figure 3-6 Fuse Replacement
Prodigy Max Operator's Manual