Datamax Prodigy Plus Operator's Manual page 121

Basic Function
BASIC FUNCTION
PRINT METHOD
DIRECT*
TRANSFER
BASIC FUNCTION
SELECT TOF
GAP*
REFLECTIVE
CONTINUOUS
BASIC FUNCTION
DARKNESS
Values 1-64
BASIC FUNCTION
COMM SETUP
*PORTA 9600
8 N 1 BOTH
BASIC FUNCTION
LABEL PRESET
ENABLE
DISABLE*
BASIC FUNCTION
CUTTER
ENABLE
DISABLE*
BASIC FUNCTION
RIBBON SAVER
ENABLE
DISABLE*
* represents default settings
Prodigy Max Operator's Manual
• Selects the type of printing desired
• Selects direct thermal printing (no ribbon installed)
• Selects thermal transfer printing (ribbon installed)
• Top Of Form
• Default looks for gap between labels
• Senses black stripe on back side on media
• No Top Of Form sensing
• Used to balance a new printhead's level of darkness
• 1 indicates the lightest and 64 indicates darkest setting
• Sets the parameters for the communication port
• Communications port and Baud rate, Word length,
Parity, Stop Bits, Protocol.
Word lengths = 7, 8
Parity
Stop Bits
Protocols
Baud rates
• Selects the Peel and Present Option
• Selects the Present Sensor
• No Present Sensor selected
• Controls Cutter Option, if installed
• Cutter Option installed or selected
• No Cutter Option installed or used
• Controls Ribbon Saver Option, if installed
• Ribbon Saver selected (stops ribbon from advancing
during voids of .95 inches or larger)
• Ribbon Saver not installed or selected
N E O
= , ,
one ven dd
= 1, 2
= BOTH, DTR, XON/XOFF
= 300, 600, 1200, 2400, 4800, 9600,
19200
31