Datamax Prodigy Plus Operator's Manual page 15

Pause Button:
Stop/Cancel Button:This Button allows the operator to stop and cancel
Feed Button:
Paper/Ribbon
Light:
Transfer on Switch: This switch should be in the 'off' position for
Darkness Control This potentiometer (POT) is used to fine adjust
POT:
Prodigy Plus
Getting Started
This button allows the operator to stop the
printing of a run of labels and then complete the
job by pressing the switch again. Activation of the
switch will: stop the print mechanism when the
label printing is complete; turn on the Pause Light;
stop the label counter, but maintain the count
balance, and; hold all data in memory. Pressing
the switch a second time will: restart the Printer;
print the balance of labels on the counter unless
interrupted, and; turn 'off' the Pause Indicator.
a run of labels in the process of being produced
and continue on to the next run in the Printer's
buffer.
Pressing the Feed Button causes the paper to
automatically advance to the first print position of
the next label. On a new size label, multiple labels
may be fed before registration occurs.
The Paper/Ribbon light is activated when a
label and/or ribbon is not detected
Direct-Thermal Printing and in the 'on' position
for Thermal-Transfer Printing. When on, it has
two functions: the ribbon sensor is enabled, and;
the Printhead temperature is reduced, since most
Thermal-Transfer Printing does not require as
much heat as Direct-Thermal Printing.
darkness to variations in the media.
7