Datamax Prodigy Plus Operator's Manual page 38

30
4. Once the Ribbon Shield is properly positioned,
tighten the left screw that supports the Ribbon
Shield to the Printhead Mount Assembly. Re-check
the ribbon travel to make certain that the ribbon
tension is even across the entire width of the ribbon.
5. Feed three or four labels and observe the ribbon as
it travels from the Ribbon Supply Hub.
6. Feed the ribbon and paper out the front of the
Printer together and check the ribbon for drifting. If
the ribbon overlaps one edge of the paper stock, the
ribbon and paper are not following the same path.
In this case, the paper tracking may need to be re-
adjusted. If there is no ribbon overlap, then
continue.
Troubleshooting
Prodigy Plus