Measurement (P920 To P927) - Siemens MAG 1100 Operating Instructions Manual

P913 Sensor Temperature
Access this parameter to display the temperature in °C (as monitored by the TS-3).
Primary Index
Values
OPEn is displayed if a TS-3 is not connected.
P914 mA Input [MR 200]
Use this feature to display the mA input value (in mA).
Primary Index
Values

Measurement (P920 to P927)

All of these parameters are available in RUN mode and used to verify programming. See
Readings in RUN Mode
The range and values shown for each of these parameters depends on the Operation
(P001) chosen. The readings for each operation are listed below.
To Access in RUN Mode
1. Ensure the device is in RUN mode.
2. Press .The Auxiliary Reading field becomes underscores P_ _ _
P
3. Type the parameter number. The field changes to the value of the specified
parameter.
These parameters are also available in simulation mode. See the
Configuration
section page 85 for instructions on how to control the simulation direction
and rate.
P920 Reading Measurement
Corresponds to the final reading after all programming is applied.
Please note that the following features apply only to the MultiRanger 200: Difference,
Average, OCM, and Pump Totalizer.
Primary Index
Values
In general this means that: P920 = (Reading x P061) + P062.
Page 218 MultiRanger 100/200 – INSTRUCTION MANUAL
Global
Range: -50 to 150
mA input
Range: 0.000 to 24.00
on page 22.
Level
Range: -999 to 9999
Testing the
7ML19981FB05