Quick Setup; Activating Sitrans Probe Lu; Setting The Profibus Address Via The Handheld Programmer - Siemens Sitrans Probe LU Instruction Manual

Oxley Creek WWTP Water Reclamation
(Probe LU Manual) Vendor Manual

Quick Setup

Activating SITRANS Probe LU

Note:
Keep infrared devices such as laptops, cell phones, and PDAs, away from
SITRANS Probe LU to prevent inadvertent operation.
Power up the instrument. SITRANS Probe LU starts in
the output of AIFB1.

Setting the PROFIBUS address via the handheld programmer

Notes:
• Local programming must be enabled, to allow changes. (In PDM, go to
•
• Press
• Press
PROGRAM icon is not visible).
1. Press
mode and open Menu level 1.
2. Press
to PROFIBUS address.
3. Press
mode: the PROGRAM icon will flash.
4. Key in a new value and press
to accept it.
The LCD displays the new value; PROGRAM
icon disappears, and the last menu digit
flashes to indicate Navigation mode.
5. Press
1.
Default address is 126.
7ML19985JB02
can be used to clear the field.
to open Edit mode: the PROGRAM icon flashes.
to cancel Edit mode: the Menu number flashes (the
to activate
twice to navigate
again to open Edit
to return to RUN mode.
SITRANS Probe LU (PROFIBUS PA) – INSTRUCTION MANUAL
mode, and the LCD displays
and select the desired setting.)
Menu level: last
digit flashes in
Navigation mode.
Program icon:
flashes in Edit
mode.
Right-most digit
flashes in
Navigation
mode.
Doc Id: VM11
Active Date: 15/12/2006
1
Page 19