List Of Error Numbers - Siemens MAG 1100 Operating Instructions Manual

SITRANS F M
8.7.2

List of error numbers

82
8. Commissioning
Error Error text
No. Remedy text
1 I1 - Power on
OK
I2 - Add-on module
2
Applied
3 I3 - Add-on module
Install
I4 - Param. corrected
4
OK
20 W20 - Totalizer 1
Reset manually
20 W20 - Totalizer 2
Reset manually
21 W21 - Pulse overflow
Adj. pulse settings
W22 - Batch timeout
22
Check installation
23 W23 - Batch overrun
Check installation
24 W24 - Batch neg. flow
Check flow direction
30 W30 - Overflow
Adj. Q
max.
W31 - Empty pipe
31
®
40 P40 - SENSORPROM
Insert/change
41 P41 - Parameter range
Switch off and on
42 P42 - Current output
Check cables
43 P43 - Internal error
Switch off and on
44 P44 - CT SENSORPROM
60 F60 - CAN comm. error
Transmitter/AOM
®
61 F61 - SENSORPROM
Replace
®
62 F62 - SENSORPROM
Replace
®
63 F63 - SENSORPROM
Replace
70 F70 - Coil current
Check cables
71 F71 - Internal error
Replace transmitter
Comment
Power-on has happened
A new module has been applied to the system
An add-on module is defect or has been removed.
This can be an internal add-on module
A less vital parameter in the transmitter has been re-
placed by its default value
During initialization the check of the saved totalizer
value has failed. It is not possible to rely on the
saved totalizer value anymore. The totalizer value
must be reset manually in order to rely on future
readings
During initialization the check of the saved totalizer
value has failed. It is not possible to rely on the
saved totalizer value anymore. The totalizer value
must be reset manually in order to rely on future
readings
Actual flow is too big compared with pulse width and
volume/pulse
Duration of batching has exceeded a predefined
max. time
Batch volume has exceeded a predefined maximum
overrun volume
Negative flow direction during batch
Flow is above Q settings
max.
Pipe is empty
®
SENSORPROM unit not installed
A parameter is out of range. The parameter could not
be replaced by its default value. The error will dis-
appear at the next power-on
Current loop is disconnected or the loop resistance
is too big
Too many errors occured at the same time
Some errors are not detected correctly
®
®
SENSORPROM unit has been used as CT version
CAN bus communication error. An add-on module, the
display module or the transmitter is defective
error
It is not possible to rely on the data in SENSOR-
®
PROM unit anymore
ID
®
The SENSORPROM unit ID does not comply with the
product ID.
®
The SENSORPROM unit is from another type of
product SITRANS FC, SITRANS FUS etc.
It is not possible to read from the SENSORPROM
unit anymore.
Coil excitation has failed
Internal convertion error in ASIC
Outputs Input
status status
Active Active
Active Active
Active Active
Active Active
Active Active
Active Active
Reduced
pulse width Active
Batch out-
put on zero Active
Batch out-
put on zero Active
Active Active
Max. 120 % Active
Zero Active
Active Active
Active Active
Active Active
Active Active
Active Active
Zero Inactive
Active Active
Zero Inactive
®
Active Active
Active Active
Active Active