How To Change Software; I/O Aux Board Pinout - Bay-Tek Lil Ticket Monster Service Manual

HOW TO CHANGE SOFTWARE

New Software Installation:
The hard drive contains all the information about the game: Credits per play, ticket pattern, etc.
Be sure to check this information after finishing installing new software.
Turn off game by flipping the power switch on the power strip.
Locate hard drive on motherboard.
Remove this screw with a small #1 Phillips screwdriver.
There is a small white plastic spacer under the screw.
Leave this on the board, the M.2 drive will rest on top of this spacer.
Remove the old software.
Slide the M.2 new software drive into the
slot on the motherboard as shown.
Notice the white spacer is still on the
motherboard.
Using a small # 1 screwdriver, re-insert
the screw into the motherboard to secure
the software.

I/O AUX BOARD PINOUT

AACB9605-CBL
= +12 VDC = +5 VDC
= Ground = Output
= Input
PB5
Q3
Q3
Outputs:
Q1 (PD1) Game counter
Q2 (PD0) Tickets counter
Q3 (PD6) Coin Lockout
PE6 Ticket Enable
36
AAMB12-HD/LTM
Motherboard
PB4
PE6 PD7
A1
6
PC
PD4 Q2
Q1
Inputs:
PD4 Menu Button
PC6 Select Button
PD7 Ticket Notch
PB4 Coin In
PB5 DBA In
D15 (A1) Low Ticket Switch Input