Table of Contents
Advertisement
Problem
Game not coining up
If installing a card swipe
reader, refer to Card Swipe
System Installation page in
front of manual.
Menu Buttons do
not work
BILL ACCEPTOR DIAGNOSTICS
Note: There are many different models and brands of Bill Acceptors that are used on redemption games.
Your Bill Acceptor may differ from the unit shown. Standard DBA is MEI # AE2454-U5E Part # A5AC9101
Only use 12 Volt DC Bill Acceptor
Determine if Bill Acceptor has power:
Turn game ON—The bill acceptor should make noise as stacker cycles and
green lights on outside bezel should flash.
If NO power:
Use meter to measure 12 VDC voltage at cable going into Bill Acceptor from
front I/O Aux Board
If power is OK:
Clean Bill Acceptor path to make sure there is nothing jamming
unit.
Check dipswitch settings on side of acceptor.
Make sure switch # 8 is OFF for Always Enable
ERROR CODES
Count the number of flashes on front bezel of Bill
Acceptor and follow on Bill Acceptor chart for
repair instructions.
TROUBLESHOOTING GUIDE
Probable Cause
Check for I/O board USB
cable communication.
Ensure game makes sound
when coin switch is triggered.
Game set to large amount of
credits per game.
Swap connectors at the 2
buttons.
Pinched, broken, or
disconnected wiring
Main board faulty.
Refer to "I/O Aux Board Issue" diagnostic
Section.
Check coin switches—both should be wired
normally open. If one switch is "closed" the other
will not work either. Check wiring to I/O Board.
(AACBL4A-DOORA, CE26013)
Check 12 Volt power in from Power Dist Board.
Check Game Setup Menu. Ensure Credits in
Payout Settings menu is set. Default = 1
Replace button if problem stays with button.(AAPB2700)
Inspect crimp to ensure good connection.
Check connections from menu buttons to I/O board.
Check continuity on wires. (AAPB2700, CE26012)
Replace I/O Aux Board. (AACB9605A-CBL)
34
Remedy
Advertisement
Table of Contents
