Table of Contents
Advertisement
HOW TO REMOVE HOME SENSOR
The home sensor is located on the left side of the wheel, when looking
from the back of the game.
Tools needed: 7/16" Wrench
Instructions:
Unlock the back door using a H95 key.
Remove the back door by using both handles to lift upwards and pull out.
To allow more room to remove sensor, first remove the top nut of wood
side brace using a 7/16" wrench, and remove the bolt.
Swing the wood side brace down and out of the way.
The wood block is designed to slide off this top post once the
bottom bolt is removed:
Remove the bolt, lock washer, and washer from the lower end of
the wood block using a 7/16" wrench.
The wood block with the sensor attached will now slide off the
top post.
The sensor can now be cleaned or replaced
if needed by removing the 2 Phillips screws.
Sensor is part # AACB4403
HOW TO REPLACE MONITOR
The 22" monitor can be removed from the back top of the game
Tools Needed:
1 step ladder (4-6 foot)
Phillips Screwdriver
Instructions:
Carefully climb to the top rear of cabinet.
Remove the 4 bolts using a Phillips screwdriver.
Remove the 4 screws using a # 2 square bit.
Disconnect VGA from the top of the monitor.
Unplug power cord from the top of the monitor.
The monitor can now be removed and replaced. Monitor part # A5MO2221
Note: The monitor is purposely installed in the cabinet upside down for optimal visibility.
# 2 Square bit
39
Advertisement
Table of Contents
