Bay-Tek Lil Ticket Monster Service Manual page 31

TROUBLESHOOTING GUIDE
Problem
Tickets do
not dispense
or Wrong Tickets on
amount monitor does
dispensed. not match
tickets coming
out of game.
Check for
the correct
amount of
tickets
showing on
Monitor
Tickets on
monitor do
match tickets
coming out of
game.
Tickets are empty in ticket tray
Low Tickets
message on
Faulty cable. Disconnected,
monitor
loose or broken wires.
Faulty low ticket switch.
Faulty I/O Aux Board
Light Board Issue
Colorful lights around
console and window are
not flashing.
Red and
Yellow
LEDs
Probable Cause
Opto Sensor on ticket
dispenser dirty.
Faulty ticket dispenser.
Notch on tickets cut too
shallow.
Faulty cable. Disconnected,
loose or broken wires.
Enter Diagnostic menu and
test Dispenser
Check dipswitches on I/O
Aux Board
Faulty I/O Aux Board
Settings in Menu are
incorrect.
Home Sensor not working
properly.
Encoder Sensors not
working properly.
Red power LED is normally on.
Yellow and red LED are normally
on.
Faulty Light Board.
Blow dust from sensor and clean with
isopropyl alcohol.
Replace with working dispenser to isolate the
problem. (A5TD1)
Flip tickets and load upside-down to have large
cut notch toward opto sensor.
Check connectors from ticket dispensers to I/O
Aux Board. Check for continuity.
Cables CE26013
There are many options that affect ticket payout
using the dipswitches. Refer to Dip Switch
Setting page.
Replace I/O Aux Board. AACB9605A-CBL
Enter Menu and check certain areas: Preset
Ticket Pattern in the Payout Settings Menu.
Enter Wheel Debug Menu from Diagnostic
Menu and verify number of the screen matches
the number on the wheel. Change Ticket
Pattern setting in menu if needed
Refer to "Home Sensor not working properly"
section.
Refer to "Encoder Sensors not working
properly" section.
Load tickets into tray. Ensure tickets hold down micro
switch wire.
Check connectors from low ticket switch to I/O Aux board.
Check for continuity. (CE26013)
Inspect switch and replace if needed. (AASW200)
Check dipswitches on I/O Board, Replace I/O Aux Board if
needed. AACB9605A-CBL
If it is off, then check 12 & 5 Volts DC coming
into board on cable CE26017 from Power
Distribution Board.
If solid on, then it is not communicating with
the motherboard. Check A5CBL5900 USB
cable. Swap cable with Wheel Control Board.
Watch during attract mode and see if it flashes
for a short time. Check A5CBL5900 USB
cable. Swap cable with the Wheel Board.
Replace Light Board if needed.
Part # AACB8001-LTM
31
Remedy