Doesv X Comm Driver (Pc) Support Auto - Reconnection After Fixing A Network Break; Why Doesn ' T Thev; Series Module - ICP DAS USA PDS-220F Series User Manual

ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru
3. Does VxComm Driver (PC) support auto-reconnection after fixing a
network break?
Yes, the VxComm Driver (PC) supports the auto-reconnection mechanism in version 2.00
and above. The VxComm Utility allows the user to set the Keep-Alive Time (ms) and
Connection-Broken Time (ms) in the server options.
For more details, refer to the "Adding a PDS server and configuring the VxComm
Driver" section of the VxComm Driver/Utility User Manual.
4. Why doesn't the VxComm Driver (PC) receive data from the PDS-220Fx series
module?
Make sure that the PDS-220Fx series module is operating in mode 0 (/M0). PDS-220Fx
series module has the following two communication modes:
Transparent Mode (Multi-echo, shared).
In this mode, data is echoed from the COM Ports of the
/M0
PDS-220Fx series module to each client that is connected
to the PDS-220Fx series module.
Slave Mode (Single-echo, Non-Shared).
In this mode, data is echoed from the COM Ports of the
/M1
PDS-220Fx series module to the specific client that
requested the service.
In /M1 mode, if the client does not send a request to the COM port of the PDS-220Fx
series module, then the module won't return any data to it. For more information, please
refer 5.4 "COM Port Settings" section.
Other reasons causing the problem may be: incorrect wiring, power supply problems IP
conflicts, MAC conflicts, an incorrect subnet mask or an invalid IP address. For more
details, refer to the "Diagnostics and Troubleshooting" section of the VxComm Driver/Utility
User Manual.
PDS-220Fx Series User Manual (V1.2, Apr. 2015)
Version 2.6.12
and above
87