Config - ICP DAS USA PDS-220F Series User Manual

ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru

CONFIG

7.3.22
Description: This command is used to clear the settings in the EEPROM.
Effect: Immediate
Command Argument
config = RESET
※When "Config=RESET" is used, the Password, Alias and IPFILTER settings will also be
cleared, but the IP/MASK/GATEWAY addresses will not.
※The SystemTimeout setting is also cleared to 0 by the "config=RESET" command, you
have to configure the SystemTimeout value again. The default factory setting of
SystemTimeout value should be 300000ms (= 300 seconds).
Example:
PDS-220Fx Series User Manual (V1.2, Apr. 2015)
Description
Clears the settings in the EEPROM.
After reboot, the firmware will use the new (default) settings on
EEPROM.
Note: ("RESET" MUST be in capital letters.)
74